CFTS72 Iris Ohyama Vacuum Cleaner Filter Set for and Includes Exhaust Sponge Cyclone Dust and 3 Additional Cartridges SCD-120P, SCD-181P, SCD-121P,

[Applicable models] SCD-120P, SCD-121P, SCD-L1P, SCD-R1P, SCD-180, SCD-181P, SCD-182P, SCD-183P, SCD-184P, etc. [Package Contents] CFTS72 Exhaust Filter Set - 3 Exhaust Filters + 6 Sponge Filters, 1 Cleaning Brush [High-Quality Antibacterial HEPA Filter] The filter is a critical component that determines the cleanliness of your vacuum cleaner's exhaust. The vacuum's powerful suction effectively sucks up dust, and the centrifugal force of the cyclone separates large particles from the air. Fine particles are then collected by the filter. The electrostatically charged, porous HEPA filter blocks solid pollutants in all directions, effectively capturing even the finest particles, including pollen, mold spores, pet dander, and dust mites! [Restore vacuum cleaner's suction power and cleaning effect] By replacing the filter at the appropriate time, you can reduce the strain on the vacuum cleaner's motor. This allows you to enjoy the original suction and cleaning performance. You can use it with the same performance as the original filter. [Replacement Guideline] The recommended replacement period for the filter is 3 to 6 months. The lifespan varies depending on the duration of use and the environment. If the exhaust has a damp or unusual odor, it may be due to bacterial growth, so we recommend replacing the filter with a new one. Iris Ohyama vacuum cleaner replacement filter [Compatible models] SCD-120P, SCD-121P, SCD-L1P, SCD-R1P, SCD-180, SCD-181P, SCD-182P, SCD-183P, SCD-184P, etc. [Package contents] CFTS72 Filter x 3 sets 3 additional cartridges Cleaning brush x 1 How to replace the CFTS72 filter Step 1: Press the dust cup release button and pull the dust cup forward to remove it. Step 2: Remove the exhaust filter/sponge filter. Step 3: Remove any debris and rinse with water. After rinsing, drain the water thoroughly and dry thoroughly. *If the exhaust filter is dirty, soak it in water for about 30 minutes and then rinse it under running water. Step 4: Assemble the dust cup in reverse order. *Align the protrusion on the cyclone unit with the notch on the dust cup case and install it all the way in. Step 5: Attach the dust cup to the vacuum cleaner body. 1) Insert the pin on the vacuum cleaner body into the hole at the top of the dust cup, and 2) push the dust cup in until it clicks into place. *Make sure to push the dust cup in securely.