The tool is universal device for locking the clutch disk. This tool makes a quick job of single handedly aligning the clutch and pressure plate before fitting
Allows for manual fixing (centering) and applying the clutch disc to the pressure plate in cars and trucks during installation.
Kit includes:
two sleeve anchors for different diameters of the bearings embedded in the crankshaft
one strut sleeve with a very large scope of regulation to the shaft without shaft support bearing clutch
Instructions:
Thread the funnel wheel onto the centre body, with ribs facing the same direction as those on the fixed wheel that is the smooth side of the wheel facing away from the fixed wheel. Select suitable collet, depending on clutch size, and slide onto centre shaft. Insert centre shaft and collet through centre body, and thread small wheel onto the end of the shaft.
Step 1. Place clutch plate over pressure on workbench, insert tool through centre and push down.
Step 2. Tighten the small wheel to expand the collet which is inside the clutch plate.
Step 3. Tighten the funnel wheel until contact is made with the pressure plate then turn both plates over.
Step 4. Align both plates together by slipping them sideways until both edges are parallel, then tighten the funnel shaft, holding both plates together.
Step 5. Install the both plates to the flywheel, then remove the tool by loosening the small wheel.
