Introductory TAGATORON Carbon Front AT Pivot Bumper for Assembly Instruction Manual Included [Gimmick Series] Front, Type,

★★★★★★★★★★★

We are selling from Japan. Our Products are Authentic only.

★★★★★★★★★★★ ✅This is a bumper (assembled type) that combines the features of "AT bumper" and "pivot bumper" and can withstand impacts from above and below and from the front. ✅In response to the impact from the front, the pivot moves backwards, allowing the impact from the bumps on the 5-lane course to escape. ✅It shows its true value especially when the machine receives impact from the front, such as on a rocking straight. ✅ By moving the rollers backwards, it absorbs the corner impact caused by jumping in after a jump, making it easier to screw onto the course. ✅The hardness of the pivot can be adjusted by the number of rubber wraps. If there are no steps such as a 3-lane course, you can increase the number of turns to achieve a hardness close to rigid. ✅ Can be installed on MS/FM-A/AR chassis (bumper cut required for installation) ⚠️This product is not manufactured by Tamiya Co., Ltd. It was created to be used as an introduction to parts processing, and to allow you to easily enjoy the gimmick in personal races. It cannot be used in official Mini 4WD competitions or races based on official competition rules. Product introduction ●This is a bumper (assembled type) that combines the features of the "AT bumper" and "pivot bumper" and can withstand impacts from above and below and from the front. ●In response to impact from the front, the pivot moves rearward, allowing the impact from the bumps on the 5-lane course to escape. ●It shows its true value especially when the machine receives impact from the front, such as on a rocking straight. ●By moving the rollers backwards, it absorbs the corner impact caused by jumping in after a jump, making it easier to screw onto the course. ●The hardness of the pivot can be adjusted by the number of rubber wraps. If there are no steps such as a 3-lane course, you can increase the number of turns to achieve a hardness close to rigid. ●Can be installed on MS/FM-A/AR chassis (bumper cut is required for installation) -This product is not manufactured by Tamiya Co., Ltd. It was created to be used as an introduction to parts processing, and to allow you to easily enjoy the gimmick in personal races. It cannot be used in official Mini 4WD competitions or races based on official competition rules.